about

Disc brush application case sharing

The flat brush is an end-face grinding product. The wire contains high-efficiency cutting abrasives such as alumina, silicon carbide, ceramics, and diamond. It is used for grinding and polishing of tool marks and burrs generated by machining. It is widely used in: auto parts grinding, Grinding and polishing of consumer electronic product casings, such as notebook computers, mobile phone frames, wooden handicrafts, aerospace spare parts, PCB circuit boards, etc. Deburring and polishing, can be matched on different machines or set automatic mechanical uniform grinding, dry grinding and wet grinding Grinding can be used, and wet grinding is better.
The steel shaft is polished. The plane brush rotates on the main shaft of the machine at a high speed and the steel shaft on the rotating shaft is ground at a constant speed of 360 degrees. Selecting different thicknesses can perform grinding, polishing, finishing and other processes according to different requirements of the steel shaft. Remove turning tool marks from steel axles and remove debris from them.
There are three grinding videos in the video for your reference:
The first is to install the disc brush on the CNC machine, and only need to rotate the rotating shaft, the tool marks on the workpiece can be polished brightly
The second is to install the disk brush on the robot hand. Under the flexible operation of the robot hand, the disk brush can polish the large area of ​​burrs and knife marks on the stainless steel workpiece. This is the reference of the dry grinding video.
The third is to install the disk brush on the robot hand. Under the flexible operation of the robot hand, the disk brush can perfectly polish the burrs and knife marks on it according to the curvature of the metal casing of the notebook computer. the water washed away. Also remove any debris on top. Here is the wet grinding video reference.


Post time: May-20-2022